Draytek Vigor2762 series User Manual page 498

Telnet Command:
Telnet Command:
This command is used to set the maximum number of NAT users.
Syntax Syntax
ip maxnatuser user no
Syntax Description
Syntax Description
Parameter
User no
Example
Example
> ip maxnatuser 100
% Max NAT user = 100
Telnet Command:
Telnet Command:
This command is used to set the IP policy route profile.
Syntax
Syntax
ip policy_rt [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
<command><parameter>|...]
General Setup for Policy Route
-i [value]
-e [0/1]
-o [value]
-1 [any/range]
-2
[any/ip_range/ip_subnet/d
omain]
-3 [any/range]
488
ip maxnatuser
ip maxnatuser
Description
A number specified here means the total NAT users that Vigor
router supports.
0 – It means no limitation.
ip policy_rt
ip policy_rt
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Specify an index number for setting policy route profile.
Value: 1 to 60. "-1" means to get a free policy index automatically.
0: Disable the selected policy route profile.
1: Enable the selected policy route profile.
Determine the operation of the policy route.
Value:
add – Create a new policy rotue profile.
del – Remove an existed policy route profile.
edit – Modify an existed policy route profile.
flush – Reset policy route to default setting.
Specify the source IP mode.
Range: Indicate a range of IP addresses.
Any: It means any IP address will be treated as source IP address.
Specify the destination IP mode.
Any: No need to specify an IP address for any IP address will be
treated as destination IP address.
ip_range: Indicates a range of IP addresses.
ip_subnet: Indicates the IP subnet.
domain: Indicates the domain name.
Specify the destination port mode.
Vigor2762 Series User's Guide