Draytek Vigor2762 series User Manual page 508

> ip6 internet -W 1 -M 2 -u userid -p passwd -s
broker.freenet6.net
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
>
Telnet Command:
Telnet Command:
This command allows you to display IPv6 neighbour table.
Syntax
Syntax
ip6 neigh –s [inet6_addr] [eth_addr] [LAN1|LAN2|...|LAN4|WAN1|WAN2|USB1|USB2]
ip6 neigh -d [inet6_addr] [LAN1|LAN2|...|LAN4|WAN1|WAN2|USB1|USB2]
ip6 neigh -a [inet6_addr] [-N LAN1|LAN2|...|LAN4|WAN1|WAN2|USB1|USB2]
Syntax Description
Syntax Description
Parameter
-s
-d
-a
inet6_addr
eth_addr
LAN|WAN1|WAN2
Example
Example
> ip6 neigh -s 2001:2222:3333::1111 00:50:7F:11:ac:22:WAN2
> ip6 neigh -a
I/F ADDR
STATE
-------------------------------------------------------------------------
LAN FF02::1
CONNECTED
WAN2 2001:5C0:1400:B::10B8
CONNECTED
WAN2 2001:2222:3333::1111
CONNECTED
WAN2 2001:2222:6666::1111
CONNECTED
WAN2 ::
CONNECTED
LAN ::
NONE
>
498
ip6 neigh
ip6 neigh
Description
It means to add a neighbour.
It means to delete a neighbour.
It means to show neighbour status.
Type an IPv6 address
Type submask address.
Specify an interface for the neighbor.
Neighbour 2001:2222:3333::1111 successfully added!
MAC
33-33-00-00-00-01
00-00-00-00-00-00
00-00-00-00-00-00
00-00-00-00-00-00
00-00-00-00-00-00
Vigor2762 Series User's Guide