Draytek Vigor2762 series User Manual page 504

-i [parameter]
-e[parameter]
Example
Example
> ip6 dhcp client WAN2 –p 2008::1
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> ip6 dhcp client WAN2 –n 1023456
> ip6 dhcp client WAN2 –a
Interface WAN2 has following DHCPv6 client settings:
> system reboot
Telnet Command:
Telnet Command:
This command allows you to configure DHCPv6 server.
ip6 dhcp server [-<command> <parameter>| ... ]
Syntax Description
Syntax Description
Parameter
server
[<command>
<parameter>|...]
-a
-i<pool_min_addr>
-x<pool_max_addr>
-d<addr>
-D<addr>
-c<parameter>
-e<parameter>
Example
Example
> ip6 dhcp server -d FF02::1
> ip6 dhcp server -i ff02::1
> ip6 dhcp server -x ff02::3
> ip6 dhcp server -a
% Interface LAN has following DHCPv6 server settings:
%
%
494
It means to send information request to server.
It means to enable or disable the DHCPv6 client.
1: Enable
0: Disable
DHCPv6 client enabled
request IA_PD whose IAID equals to 2008
DHCPv6 client enabled
request IA_NA whose IAID equals to 2008
ip6 dhcp server
ip6 dhcp server
Description
It means the dhcp server settings.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to show current DHCPv6 status.
It means to set the start IPv6 address of the address pool.
It means to set the end IPv6 address of the address pool.
It means to set the first DNS IPv6 address.
It means to set the second DNS IPv6 address.
It means to send rapid commit to server.
1: Enable
0: Disable
It means to enable or disable the DHCPv6 server.
1: Enable
0: Disable
DHCPv6 server disabled
maximum address of the pool: FF02::3
Vigor2762 Series User's Guide