Draytek Vigor2762 series User Manual page 578

> srv nat ipsecpass status
%% Status: IPsec ESP pass-thru and IKE src_port:500 preservation
is OFF.
Telnet Command:
Telnet Command:
This command allows users to set open port settings for NAT server.
srv nat openport n m [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
n
m
[<command>
<parameter>|...]
-a <enable>
-c <comment>
-i <local ip>
-w <idx>
-p <protocol>
-s<start port>
-e<end port>
-v
-r <remove>
-f <flush>
Example
Example
> srv nat openport 1 1 -a 1 -c games -i 192.168.1.100 -w 1 -p TCP
-s 23 -e 83
> srv nat openport -v
%% Status: Enable
%% Comment: games
%% Private IP address: 192.168.1.100
Index
*****************************************************************
568
srv nat openport
srv nat openport
Description
It means the index number for the profiles. The range is from 1 to
20.
It means to specify the sub-item number for this profile. The range
is from 1 to 10.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to enable or disable the open port rule profile.
0: disable
1:enable
It means to type the description (less than 23 characters) for the
defined network service.
It means to set the IP address for local computer.
Local ip: Type an IP address in this field.
It means to specify the public IP.
1: WAN1 Default,
2: WAN1 Alias 1,
...and so on.
Specify the transport layer protocol.
Available values are TCP, UDP and ALL.
It means to specify the starting port number of the service offered
by the local host. The range is from 0 to 65535.
It means to specify the ending port number of the service offered
by the local host.
The range is from 0 to 65535.
It means to display current settings.
It means to delete the specified open port setting.
remove: Type the index number of the profile.
It means to return to factory settings for all the open ports
profiles.
Protocal Start Port End Port
Vigor2762 Series User's Guide