Draytek Vigor2762 series User Manual page 462

PVC
------------------------------------------------------------
4
PVC 0 & 1 can't set for bridge mode.
Please use 'save' to save config.
Telnet Command:
Telnet Command:
This command is useful for laboratory to measure largest power of data transmission. Please
follow the steps below to set adsl drivermode.
1. Please connect dsl line to the DSLAM.
2. Waiting for dsl SHOWTIME.
3. Drop the dsl line.
4. Now, it is on continuous sending mode, and adsl2/2+ led is always ON.
5. Use 'adsl reboot' to restart dsl to normal mode.
Telnet Command:
Telnet Command:
This command can wake up the idle router.
Example
Example
> adsl reboot
% Adsl is Rebooting...
452
Bridge p1 p2
ON 0 0
adsl drive r mode
adsl drive r mode
adsl reboot
adsl reboot
p3 p4 Service Type
1 0 Normal
Tag Pri
-1(OFF) 0
Vigor2762 Series User's Guide