Draytek Vigor2762 series User Manual page 577

Telnet Command:
Telnet Command:
This command allows users to set DMZ host. Before using this command, please set WAN IP
Alias first.
Srv nat dmz n m [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
n
m
[<command>
<parameter>|...]
-e
-i
-r
-v
Example Example
> srv nat dmz 1 1 -i 192.168.1.96
> srv nat dmz -v
%
Index
----------------------------------------------------
1
Telnet Command:
Telnet Command:
This command allows users to enable or disable IPSec ESP tunnel passthrough and IKE source
port (500) preservation.
Srv nat ipsecpass [options]
Syntax Description
Syntax Description
Parameter
[options]
on
off
status
Example
Example
Vigor2762 Series User's Guide
srv nat dmz
srv nat dmz
Description
It means to map selected WAN IP to certain host.
1: wan1
2: wan2
It means the index number of the DMZ host.
Default setting is "1" (WAN 1). It is only available for Static IP
mode. If you use other mode, you can set 1 ~ 8 in this field. If WAN
IP alias has been configured, then the number of DMZ host can be
added more.
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means to enable/disable such feature.
1:enable
0:disable
It means to specify the private IP address of the DMZ host.
It means to remove DMZ host setting.
It means to display current status.
WAN1 DMZ mapping status:
Status WAN1 aux IP
Disable 0.0.0.0 192.168.1.96
srv nat ipsecpass
srv nat ipsecpass
Description
The available commands with parameters are listed below.
It means to enable IPSec ESP tunnel passthrough and IKE source
port (500) preservation.
It means to disable IPSec ESP tunnel passthrough and IKE source
port (500) preservation.
It means to display current status for checking.
Private IP
567