Draytek Vigor2762 series User Manual page 373

To set a new profile, please do the steps listed below:
1. Click the number (e.g., #1) under Index column for configuration in details.
2. The configuration page will be shown as follows:
Available settings are explained as follows:
Item
Name
Address Type
Match Type
Mac Address
Start IP Address
End IP Address
Vigor2762 Series User's Guide
Description
Type a name for this profile. Maximum 15 characters are
allowed.
Determine the address type for the IPv6 address.
Select Single Address if this object contains one IPv6
address only.
Select Range Address if this object contains several IPv6s
within a range.
Select Subnet Address if this object contains one subnet for
IPv6 address.
Select Any Address if this object contains any IPv6 address.
Select Mac Address if this object contains Mac address.
Specify which type (128 Bits or 64 Bits) of address fomat for
IPv6 protocol will be used for comparison. The length of
IPv6 address is composed by prefix and suffix (interface ID).
128 Bits – When it is selected, Vigor router will make the
completed comparison for IPv6 protocol based on prefix and
suffix.
Suffix 64 Bits (Interface ID) - When it is selected, Vigor
router will make the simplified comparison for IPv6 protocol
based on suffix only.
Type the MAC address of the network card which will be
controlled.
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
363