Draytek Vigor2762 series User Manual page 495

Telnet Command:
Telnet Command:
This command allows users to set maximum session limit number for the specified IP; set
message for exceeding session limit and set how many seconds the IP session block works.
ip session on
ip session off
ip session default [num]
ip session defaultp2p [num]
ip session status
ip session show
ip session timer [num]
ip session [block/unblock][IP]
ip session [add/del][IP1-IP2][num][p2pnum]
Syntax Description Syntax Description
Parameter
on
off
default [num]
Defautlp2p [num]
status
show
timer [num]
[block/unblock][IP]
add
del
IP1-IP2
num
p2pnum
Example
Example
>ip session default 100
> ip session add 192.168.1.5-192.168.1.100 100 50
> ip session on
> ip session status
IP range:
192.168.1.5 - 192.168.1.100 : 100
Current ip session limit is turn on
Current default session number is 100
Vigor2762 Series User's Guide
ip session
ip session
Description
Turn on session limit for each IP.
Turn off session limit for each IP.
Set the default number of session num limit.
Set the default number of session num limit for p2p.
Display the current settings.
Display all session limit settings in the IP range.
Set when the IP session block works.
The unit is second.
Block/unblock the specified IP address.
Block: The IP cannot access Internet through the router.
Unblock: The specified IP can access Internet through the router.
Add the session limits in an IP range.
Delete the session limits in an IP range.
It means the range of IP address specified for this command.
It means the number of the session limits, e.g., 100.
It means the number of the session limits, e.g., 50 for P2P.
485