Draytek Vigor2762 series User Manual page 635

> wan multifno status
% Channel 3 uplink ifno: 3
% Channel 4 uplink ifno: 3
% Channel 5 uplink ifno: 3
% Channel 6 uplink ifno: 3
% Channel 7 uplink ifno: 3
>
Telnet Command:
Telnet Command:
This command allows you to tag packets on WAN VLAN with specified number.
Syntax
Syntax
wan vlan wan [#] adsl tag [value]
wan vlan wan [#] adsl [enable|disable]
wan vlan wan [#] adsl pri[value]
wan vlan wan [#] vdsl tag [value]
wan vlan wan [#] vdsl [enable|disable]
wan vlan wan [#] vdsl pri[value]
wan vlan stat
Syntax Description
Syntax Description
Parameter
#
value
enable|disable
pri[value]
stat
Example Example
> wan vlan stat
%Interface
%======================================
% WAN1 (ADSL)
% WAN1 (VDSL)
%WAN2
Telnet Command:
Telnet Command:
This command allows you determine the data traffic volume for each WAN interface
respectively to prevent from overcharges for data transmission by the ISP.
Syntax
Syntax
wan budget wan [#] rdate [day] [hour]
wan budget wan [#] [enable|disable]
Vigor2762 Series User's Guide
wan vlan
wan vlan
Description
It means the number of WAN interface.
1: means WAN1
2: means WAN2.
It means the number to be tagged on packets.
The range of the value is between 32 ~ 4095.
It means to enable or disable the WAN interface for VLAN.
It means to set priority of data transmission via 802.1q.
The range of the value is between 0 ~ 7.
It means to display the table of WAN VLAN status.
Pri Tag
0 0
0 0
0 0
wan budget
wan budget
Enabled
625