Draytek Vigor2762 series User Manual page 463

Telnet Command:
Telnet Command:
This command is used to test if the connection between CPE and CO is OK or not.
adsl oamlb [n][type]
adsl oamlb chklink [on/off]
adsl oamlb [log_on/log_off]
Syntax Description
Syntax Description
Parameter
Parameter
n
type
chklink
Log_on/log_off
Example
Example
> adsl oamlb chklink on
OAM checking dsl link is ON.
> adsl oamlb F5 4
Tx cnt=0
Rx Cnt=0
>
Telnet Command:
Telnet Command:
This command can cancel the limit for vci value.
Some ISP might set the vci value under 32. In such case, we can cancel such limit manually
by using this command. Do not set the number greater than 254.
adsl vcilimit [n]
Syntax Description
Syntax Description
Parameter Parameter
n
Example
Example
> adsl vcilimit 33
change VCI limitation from 32 to 33.
Vigor2762 Series User's Guide
adsl oamlb
adsl oamlb
Description
Description
It means the total number of transmitted packets.
It means the protocol that you can use.
1 – for F4 Seg-to-Seg (VP level)
2 – for F4 End-to-End (VP level)
4 – for F5 Seg-to-Seg (VC level)
5 – for F5 End-to-End (VC level)
Check the DSL connection.
Enable or disable the OAM log for debug.
adsl vcilimit
adsl vcilimit
Description Description
The number shall be between 1 ~ 254.
453