Draytek Vigor2762 series User Manual page 519

---------------------------------------------------------------
Apply IP filter to VPN incoming packets
Accept large incoming fragmented UDP or ICMP packets: Enable
----------------------------------------------------------------
Strict Security Checking
[ ]APP Enforcement
>
Telnet Command:
Telnet Command:
This command is used to set filter rule for firewall.
ipf rule s r [-<command> <parameter> | ...
ipf rule s r -v
Syntax Description
Syntax Description
Parameter
s
r
<Command><parameter>
-e
-s o:g <obj>
–s u <Address Type> <Start
IP Address> <End IP
Address> | <Address Mask>
–d u <Address Type> <Start
IP Address> <End IP
Address> | <Address Mask>
Vigor2762 Series User's Guide
ipf rule
ipf rule
Description
Such word means Filter Set, range form 1~12.
Such word means Filter Rule, range from 1~7.
The following lists all of the available commands with parameters.
It means to enable or disable the rule setting.
0- disable
1- enable
It means to specify source IP object and IP group.
o - indicates "object".
g - indicates "group".
obj - indicates index number of object or index number of group.
Available settings range from 1-192. For example, "-s g 3" means
the third source IP group profile.
It means to configure source IP address including address type,
start IP address, end IP address and address mask.
u – It means "user defined".
Address Type - Type the number (representing different address
type).
0 - Subnet Address
1 - Single Address
2 - Any Address
3 - Range Address
Example:
Set Subnet Address => -s u 0 192.168.1.10 255.255.255.0
Set Single Address => -s u 1 192.168.1.10
Set Any Address => -s u 2
Set Range Address => -s u 3 192.168.1.10 192.168.1.15
It means to configure destination IP address including address
type, start IP address, end IP address and address mask.
u – It means "user defined".
Address Type - Type the number (representing different address
type).
0 - Subnet Address
1 - Single Address
2 - Any Address
3 - Range Address
: Enable
509