Draytek Vigor2762 series User Manual page 564

Level2: It will be applied when the NAT sessions are smaller than the eighth of the default
setting.
Example
Example
> show pmtime
Level0 TCP=86400001 UDP=300001 ICMP=10001
Level1 TCP=600000 UDP=90000 ICMP=7000
Level2 TCP=60000 UDP=30000 ICMP=5000
Telnet Command:
Telnet Command:
This command displays current status of current session.
Example
Example
> show session
% Maximum Session Number: 50000
% Maximum Session Usage: 0
% Current Session Usage: 0
% Current Session Used(include waiting for free): 0
% WAN1 Current Session Usage: 0
% WAN2 Current Session Usage: 0
% WAN3 Current Session Usage: 0
% WAN4 Current Session Usage: 0
>
Telnet Command:
Telnet Command:
This command displays current status of LAN and WAN connections.
Example
Example
> show status
System Uptime:1:4:49
LAN Status
Primary DNS:8.8.8.8
IP Address:192.168.1.1
WAN 1 Status: Disconnected
Enable:Yes
Mode:PPPoE
TX Packets:0
WAN 2 Status: Disconnected
Enable:Yes
Mode:---
TX Packets:0
WAN 3 Status: Disconnected
Enable:Yes
Mode:---
TX Packets:0
WAN 4 Status: Disconnected
554
show session
show session
show status
show status
Secondary DNS:8.8.4.4
Tx Rate:3266
Line:xDSL
Up Time:0:00:00
TX Rate:0
Line:Ethernet
Up Time:0:00:00
TX Rate:0
Line:USB
Up Time:0:00:00
TX Rate:0
Rx Rate:2245
Name:
IP:---
RX Packets:0
Name:
IP:---
RX Packets:0
Name:
IP:---
RX Packets:0
Vigor2762 Series User's Guide
GW IP:---
RX Rate:0
GW IP:---
RX Rate:0
GW IP:---
RX Rate:0