Draytek Vigor2762 series User Manual page 483

WAN1 ISP Name set to tcom
WAN1 Username set to username
WAN1 Password set successful
WAN1 PPP Authentication Type set to PAP/CHAP
WAN1 Idle timeout set to always-on
WAN1 Gateway IP set to 0.0.0.0
> internet -V
WAN1 Internet Mode:PPPoE
ISP Name: tcom
Username: username
Authentication: PAP/CHAP
Idle Timeout: -1
WAN IP: Dynamic IP
> internet -W 1 -M 1 -u link1 -p link1 -a 0
You are going to watching and setting in WAN 1
WAN1 Internet Mode set to PPPoE/PPPoA
WAN1 Username set to link1
WAN1 Password set successful
WAN1 PPP Authentication Type set to PAP/CHAP
>
Telnet Command:
Telnet Command:
This command allows users to enable or disable the IP routing subnet for your router.
Syntax
Syntax
ip pubsubnet <Enable/Disable>
Syntax Description
Syntax Description
Parameter
Enable
Disable
Example
Example
> ip 2ndsubnet enable
public subnet enabled!
Telnet Command:
Telnet Command:
This command allows to set the IP routed subnet for the router.
Syntax Syntax
ip pubaddr ?
ip pubaddr <public subnet IP address>
Syntax Description
Syntax Description
Parameter
?
public subnet IP address
Vigor2762 Series User's Guide
ip pub subnet
ip pub subnet
Description
Enable the function.
Disable the function.
ip pub addr
ip pub addr
Description
Display an IP address which allows users set as the public subnet IP
address.
Specify an IP address. The system will set the one that you
473