Draytek Vigor2762 series User Manual page 370

MAC Address
Start IP Address
End IP Address
Subnet Mask
Invert Selection
3. After finishing all the settings here, please click OK to save the configuration. Below is
an example of IP objects settings.
360
Type the MAC address of the network card which will be
controlled.
Type the start IP address for Single Address type.
Type the end IP address if the Range Address type is
selected.
Type the subnet mask if the Subnet Address type is
selected.
If it is checked, all the IP addresses except the ones listed
above will be applied later while it is chosen.
Vigor2762 Series User's Guide