Draytek Vigor2762 series User Manual page 619

mywip
rgip
rnip
rnmask
rip
mode
droute
Example
Example
> vpn option 1 idle=250
% Change Log..
% Idle Timeout = 250
Telnet Command:
Telnet Command:
This command allows users to list, add or delete static routes for a certain LAN to LAN VPN
profile.
vpn mroute <index> list
vpn mroute <index> add <network ip>/<mask>
vpn mroute <index> del <network ip>/<mask>
Syntax Description
Syntax Description
Parameter
list
add
del
<index>
<network ip>/<mask>
Example
Example
Vigor2762 Series User's Guide
It means My WAN IP.
"mywip=1.2.3.4" means to set My WAN IP as "1.2.3.4".
It means Remote Gateway IP.
"rgip=1.2.3.4" means to set Remote Gateway IP as "1.2.3.4".
It means Remote Network IP.
"rnip=1.2.3.0" means to set Remote Network IP as "1.2.3.0".
It means Remote Network Mask.
"rnmask=255.255.255.0" means to set Remote Network Mask as
"255.255.255.0".
It means RIP Direction.
"rip=d" means to set RIP Direction as "Disable".
"rip=t" means to set RIP Direction as "TX".
"rip=r" means to set RIP Direction as "RX".
"rip=b" means to set RIP Direction as "Both".
It means the option of "From first subnet to remote network, you
have to do".
"mode=r" means to set Route mode.
"mode=n" means to set NAT mode.
It means to Change default route to this VPN tunnel ( Only single
WAN supports this).
droute=on/off means to enable/disable the function.
vpn mroute
vpn mroute
Description
It means to display all of the route settings.
It means to add a new route.
It means to delete specified route.
It means the index number of the profile.
Available index numbers:
1 ~ 32
Type the IP address with the network mask address.
609