Draytek Vigor2762 series User Manual page 633

Set OK
> wan detect wan1 on
Set OK
> wan detect status
WAN1: on, Target=192.168.1.78, TTL=255
WAN2: off
WAN3: off
WAN4: off
WAN5: off
>
Telnet Command:
Telnet Command:
This command allows you to Enable/Disable for each WAN to join auto load balance
member.
wan lb [wan1/wan2/...] on
wan lb [wan1/wan2/...] off
Syntax Description
Syntax Description
Parameter
wan1/wan2
on
off
Example
Example
> wan lb status
WAN1: on
WAN2: on
WAN3: on
WAN4: on
WAN5: on
WAN6: on
WAN7: on
Telnet Command:
Telnet Command:
This command allows you to configure multi-VLAN for WAN and LAN. It supports pure bridge
mode (modem mode) between Ethernet WAN and LAN port 2~4.
wan mvlan [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service
type/vlan priority] [px ... ][ Keep Tag]
Syntax Description Syntax Description
Parameter
pvc_no
status
save
Vigor2762 Series User's Guide
wan lb
wan lb
Description
It means to specify which WAN will be applied with load balance.
It means to make WAN interface as the member of load balance.
It means to cancel WAN interface as the member of load balance.
wan mvlan
wan mvlan
Description
It means index number of PVC. There are 10 PVC, 0(Channel-1) to
9(Channel-9) allowed to be configured.
However, only 2 to 9 are available for configuration.
It means to display the whole Bridge status.
It means to save the configuration into flash of Vigor router.
623