Draytek Vigor2762 series User Manual page 537

This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to configure the subnet for NAT or Routing usage.
msubnet nat [2/3/4] [On/Off]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
On/Off
Example
Example
> > msubnet nat 2 off
% LAN2 Subnet is for Routing usage!
%Note: If you have multiple WAN connections, please be reminded to
setup a Load-Balance policy so that packets from this subnet will
be forwarded to the right WAN interface!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to configure an IP address as the gateway used for subnet.
msubnet gateway [2/3/4] [Gateway IP]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
Gateway IP
Example
Example
> msubnet gateway 2 192.168.1.13
% Set LAN2 Dhcp Gateway IP done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to defined the total number allowed for each LAN interface.
Vigor2762 Series User's Guide
msubnet nat
msubnet nat
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
On – It means the subnet will be configured for NAT usage.
Off - It means the subnet will be configured for Routing usage.
msubnet gateway
msubnet gateway
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Specify an IP address as the gateway IP.
msubnet ipcnt
msubnet ipcnt
527