Draytek Vigor2762 series User Manual page 555

%Set Port 1 Force speed 100 Full duplex OK !!!
Telnet Command:
Telnet Command:
This command allows you to set a time of keeping the session connection for specified
protocol.
portmaptime [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
[<command>
<parameter>|...]
-t <sec>
-u <sec>
-i <sec>
-w <sec>
-s <sec>
-f
-l <List>
Example
Example
> portmaptime -t 86400 -u 300
> portmaptime -l
------ Current setting ------
TCP Timeout
UDP Timeout
IGMP Timeout
TCP WWW Timeout: 60 sec.
TCP SYN Timeout: 60 sec.
Telnet Command: ppa
Telnet Command: ppa
This command allows you to configure PPA mode.
ppa [-<command> <parameter> | ... ]
ppa n [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
[<command>
<parameter>|...]
-m <mode>
Vigor2762 Series User's Guide
portmaptime
portmaptime
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
It means "TCP" protocol.
<sec>: Type a number to set the TCP session timeout.
It means "UDP" protocol.
<sec>: Type a number to set the UDP session timeout.
It means "IGMP" protocol.
<sec>: Type a number to set the IGMP session timeout.
It means "TCP WWW" protocol.
<sec>: Type a number to set the TCP WWW session timeout.
It means "TCP SYN" protocol.
<sec>: Type a number to set the TCP SYN session timeout.
It means to flush all portmaps (useful for diagnostics).
List all settings.
: 86400 sec.
: 300 sec.
: 10 sec.
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Specify a mode.
1=auto
-i 10
545