Draytek Vigor2762 series User Manual page 500

-b [value]
Diagnose for Policy Route
-s [value]
-d [value]
-p [value]
-t [value]
Example
Example
> ip policy_rt diagnose -s 192.168.1.100 -d any -p any -t ICMP
-------------------------------------------------
-------------------------------------------------
* No_Match
-------------------------------------------------
-------------------------------------------------
* Policy_1 (200)
* Conclusion:The packet was dropped because the send-to
interface of the mat
ched policy "policy 1" was inactive and there was no failover
setting
>
ip policy_rt -i -1 -o add -1 range -s 192.168.1.10 -S 192.168.1.20 -2
ip_range –d 202.211.100.10 -D 202.211.100.20 -g 202.211.100.1 -I WAN2
Telnet Command:
Telnet Command:
This command is used to set LAN DNS profile.
Syntax
Syntax
ip lanDNSRes [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
[<command>
<parameter>|...]
490
VPN_PROFILE_1 ~ VPN_PROFILE_100,
WAN_1_IP_ALIAS_1 ~ WAN_4_IP_ALIAS_8
It means "failback".
Value: Available settings include,
0: Disable the function of "failback".
1: Enable the function of "failback".
-v: View current failback setting.
It means "source IP".
Value: Available settings include:
Any: It indicates any IP address can be used as source IP address.
"xxx.xxx.xxx.xxx": The type format (e.g, 192.168.1.0).
It means "destination IP".
Value : Available settings include:
Any: It indicates any IP address can be used as destination IP
address.
"xxx.xxx.xxx.xxx": Specify an IP address.
It means "destination port".
Value: Specify a number or type Any (indicating any number).
It means "protocol".
Value: Available settings include "ICMP", "TCP", "UDP" and "Any".
Matched Route (Priority)
Matched Policy (Priority)
ip lanDNSRes
ip lanDNSRes
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Vigor2762 Series User's Guide