Draytek Vigor2762 series User Manual page 536

2/3/4/5/6
IP address
Example
Example
> msubnet nmask 2 255.255.0.0
% Set LAN2 subnet mask done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to display current status of subnet.
msubnet status [2/3/4]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
Example Example
> msubnet status 2
% LAN2
% DHCP server: Off
% Dhcp Gateway: 0.0.0.0, Start IP: 0.0.0.10, Pool Count: 50
Telnet Command:
Telnet Command:
This command allows you to enable or disable DHCP server for the subnet.
msubnet dhcps [2/3/4][On/Off]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
On/Off
Example
Example
> msubnet dhcps 3 off
% LAN3
526
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Type the subnet mask address for the specified LAN interface.
msubnet status
msubnet status
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Off: 0.0.0.0/0.0.0.0, PPP Start IP: 0.0.0.60
msubnet dhcps
msubnet dhcps
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
On means enabling the DHCP server for the specified LAN
interface.
Off means disabling the DHCP server.
Subnet DHCP Server disabled!
Vigor2762 Series User's Guide