I-6-1 For Wan1 (Adsl) - Draytek Vigor2762 series User Manual

I-6-1 For WAN1 (ADSL)

I-6-1 For WAN1 (ADSL)
WAN1 is specified for ADSL or VDSL2 connection.
Available settings are explained as follows:
Item
Display Name
VLAN Tag insertion
(VDSL2)/(ADSL)
Please select the appropriate Internet access type according to the information from your
ISP. Click Next.
PPPoE/PPPoA
PPPoE/PPPoA
PPPoE stands for Point-to-Point Protocol over Ethernet. It relies on two widely accepted
standards: PPP and Ethernet. It connects users through an Ethernet to the Internet with a
common broadband medium, such as a single DSL line, wireless device or cable modem. All
the users over the Ethernet can share a common connection.
PPPoE is used for most of DSL modem users. All local users can share one PPPoE connection
for accessing the Internet. Your service provider will provide you information about user
name, password, and authentication mode.
1. Choose WAN1 as WAN Interface and click the Next button; you will get the following
page. Choose PPPoE XXXX or PPPoA XXXXX as the protocol.
28
Description
Type a name to identify such WAN.
The settings configured in this field are available for WAN1
and WAN2.
Enable – Enable the function of VLAN with tag.
The router will add specific VLAN number to all packets on
the WAN while sending them out.
Please type the tag value and specify the priority for the
packets sending by WAN1.
Disable – Disable the function of VLAN with tag.
Tag value – Type the value as the VLAN ID number. The
range is from 0 to 4095.
Priority – Type the packet priority number for such VLAN.
The range is from 0 to 7.
Vigor2762 Series User's Guide