Draytek Vigor2762 series User Manual page 459

Telnet Command: adsl txpct /adsl rxpct
Telnet Command: adsl txpct /adsl rxpct
This command allows the user to adjust the percentage of data transmission
(receiving/transmitting) for QoS application.
Syntax
Syntax
adsl txpct [auto:percent]
adsl rxpct [auto:percent]
Syntax
auto
percent
Example
Example
> adsl txpct auto
% tx percentage : 80
> adsl txpct 75
% tx percentage : 75
Telnet Command: adsl status
Telnet Command: adsl status
This command is used to display current status of ADSL setting.
Syntax
Syntax
adsl status
Example
Example
> adsl status
--------------------- ATU-R Info (hw: annex A, f/w: annex A) ----------
Running Mode
DS Actual Rate
bps
DS Attainable Rate
bps
DS Path Mode
Fast
DS Interleave Depth
NE Current Attenuation
dB
DS actual PSD
dB
NE Rcvd Cells
NE CRC Count
NE ES Count
Xdsl Reset Times
ITU Version[0]
ADSL Firmware Version
Power Management Mode
Test Mode
----------------------- ATU-C Info ---------------------------------
Far Current Attenuation :
dB
Vigor2762 Series User's Guide
Description
It means auto detection of ADSL transmission packet.
It means to specify the percentage of ADSL transmission
packet. Available range is 10-100.
: State
: 0 bps US Actual Rate
: 0 bps US Attainable Rate
: Fast US Path Mode
: 0 US Interleave Depth
: 0 dB Cur SNR Margin
: 0. 0 dB US actual PSD
: 0 NE Xmitted Cells
: 0 FE CRC Count
: 0 FE
: 0 Xdsl Link
: b5004946 ITU Version[1]
: 06-06-01-07-00-01
: DSL_G997_PMS_NA
: DISABLE
0 dB Far SNR Margin
: TRAINING
:
:
:
:
:
:
:
:
ES Count :
Times :
: 544e0000
:
0
0
0
0
0. 0
0
0
0
0
0
449