Draytek Vigor2762 series User Manual page 534

mask
remove
flush
Example Example
> mngt accesslist add 1 192.168.1.89 255.255.255.0
%% Set OK.
> mngt accesslist list
%% Access list :
Index IP address
==========================================
1
Telnet Command:
Telnet Command:
This command allows you to configure SNMP for management.
mngt snmp [-<command> <parameter> | ... ]
Syntax Description Syntax Description
Parameter
[<command>
<parameter>|...]
-e <1/2>
-g<Community name>
-s <Community name>
-m <IP address>
-t <Community name>
-n <IP address>
-T <seconds>
-V
Example
Example
> mngt snmp -e 1 -g draytek -s DK -m 192.168.1.1 -t trapcom -n
10.20.3.40 -T 88
SNMP Agent Turn on!!!
Get Community set to draytek
Set Community set to DK
Manager Host IP set to 192.168.1.1
Trap Community set to trapcom
Notification Host IP set to 10.20.3.40
Trap Timeout set to 88 seconds
524
It means to specify the subnet mask for the IP address.
It means to delete the selected item.
It means to remove all the settings in the access list.
Subnet mask
192.168.1.89 255.255.255.0
mngt snmp
mngt snmp
Description
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
1: Enable the SNMP function.
2: Disable the SNMP function.
It means to set the name for getting community by typing a proper
character. (max. 23 characters)
It means to set community by typing a proper name. (max. 23
characters)
It means to set one host as the manager to execute SNMP function.
Please type in IPv4 address to specify certain host.
It means to set trap community by typing a proper name. (max. 23
characters)
It means to set the IPv4 address of the host that will receive the
trap community.
It means to set the trap timeout <0~999>.
It means to list SNMP setting.
Vigor2762 Series User's Guide