Draytek Vigor2762 series User Manual page 535

Telnet Command:
Telnet Command:
This command is used to configure multi-subnet.
msubnet switch [2/3/4][On/Off]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
On/Off
Example
Example
> msubnet switch 2 On
% LAN2
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to configure IP address for the specified LAN interface.
msubnet addr [2/3/4][IP address]
Syntax Description
Syntax Description
Parameter
2/3/4/5/6
IP address
Example Example
> msubnet addr 2 192.168.5.1
% Set LAN2 subnet IP address done !!!
This setting will take effect after rebooting.
Please use "sys reboot" command to reboot the router.
Telnet Command:
Telnet Command:
This command is used to configure net mask address for the specified LAN interface.
msubnet nmask [2/3/4][IP address]
Syntax Description
Syntax Description
Parameter
Vigor2762 Series User's Guide
msubnet switch
msubnet switch
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
On means turning on the subnet for the specified LAN interface.
Off means turning off the subnet.
Subnet On!
msubnet addr
msubnet addr
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
Type the private IP address for the specified LAN interface.
msubnet nmask
msubnet nmask
Description
525