Draytek Vigor2762 series User Manual page 485

Example Example
> ip aux add 192.168.1.65 1
% 192.168.1.65 has added in index 3.
When you type ip aux?, the current auxiliary WAN IP Address table will be shown as the
following:
Index no.
----------------------------------------------
1
2
3
Telnet Command:
Telnet Command:
This command allows users to set/add a specified LAN IP your router.
Syntax
Syntax
ip addr [IP address]
Syntax Description
Syntax Description
Parameter
IP address
Example
Example
>ip addr 192.168.50.1
% Set IP address OK !!!
Info
Telnet Command: ip
Telnet Command: ip
This command allows users to set/add a specified netmask for your router.
Syntax
Syntax
ip nmask [IP netmask]
Syntax Description
Syntax Description
Parameter
IP netmask
Example
Example
Vigor2762 Series User's Guide
Status IP address
Enable 172.16.3.229
Enable 172.16.3.56
Enable 172.16.3.113
ip addr
ip addr
Description
The LAN IP address.
When the LAN IP address is changed, the start IP address of DHCP server
are still the same. To make the IP assignment of the DHCP server being
consistent with this new IP address (they should be in the same network
segment), the IP address of the PC must be fixed with the same LAN IP
address (network segment) set by this command for accessing into the web
user interface of the router. Later, modify the start addresses for the
DHCP server.
nmask
nmask
Description
The netmask of LAN IP.
IP pool
Yes
No
No
475