Draytek Vigor2762 series User Manual page 624

lb <add/del> <name>
<Member#1> <Member#2>
lb algorithm <name>
<RR/W-RR/Fastest>
lb algorithm <name><W-
RR><Auto>
<AccordingRatio>
<Member1:Member2>
lb algorithm
<name><Fastest>
bind usage <BindIndex>
bind show
<LoadBalanceName>
bind reset_default
bind set <BindIndex> <ACT>
<TrunkName> <Member>
<SrcIp:A~B> <DstI p:A~B>
<DstPort:A~B> <Proto>
<Frag>
614
2147483647" means to early handle for less than 30 seconds within
designated time.
It means to create VPN trunk with load balance.
add/del - Add or delete a profile for used in VPN Trunk.
name – Specify the name of the VPN trunk.
Member#1 – Indicate the first LAN to LAN profile.
Member#2 – Indicate the second LAN to LAN profile.
Set multiple VPN tunnels for using as traffic load balance tunnel.
Such command is to configure the algorithm (with round robin
mode) of Load Balance.
name – Specify the name of the VPN trunk.
RR – It means round robin mode. All of the dial-out profiles will be
taken turns equally.
Such command is to configure the algorithm (with round robin
mode) of Load Balance.
name – Specify the name of the VPN trunk.
W-RR – It means weighted round robin mod based on speed ratio.
 Auto - the speed must be based on Lay2.
AccordingRatio – the speed must be based on given ratio.

Member#1 – Inidcate the first LAN to LAN profile.
Member#2 – Indicate the second LAN to LAN proifle.
Such command is to configure the algorithm (with fastest mode) of
Load Balance. Most of traffics will be led to the channel with the
fastest connection.
name – Specify the name of the VPN trunk.
Display detailed information for VPN Load Balance Tunnel Bind.
BindIndex – Indicate the index number of the tunnle bind.
Display the bind information for VPN Load Balance profile.
LoadBalanceName – type the name of VPN Load Balance profile
Reset the bind tunnel for VPN load balance to factory reset
settings.
Set the binding tunnel policy.
BindIndex – Indicate the index number (1 ~ 64) for the tunnel to be
bound.
vpn trunk bind set 1 y vpnlb 1
192.168.10.1~192.168.10.2
192.168.99.1~192.168.99.254 1~65535 0 OFF
ACT – Specify the action. "y" means active; "n" means inactive or
delete.
TrunkName - TrunkName - Specify the name of the VPN trunk
created by using "vpn trunk lb" command.
Member – Specify the index number of the LAN to LAN (dial-out)
profile to be bound.
SrcIp:A~B – Specify the source IP range (e.g.,
192.168.10.0~192.168.10.255.
DstI p:A~B - Specify the destination IP range (e.g.,
192.168.1.0~192.168.1.255.
DstPort:A~B – Specify the destination port range (1~65535).
Proto – Specify the protocol.
0 – any
1 – ICMP
2 – IGMP
6 – TCP
17 – UDP
Vigor2762 Series User's Guide