Draytek Vigor2762 series User Manual page 102

General Settings
ATM OoS
Open Port-based Bridge
Connection for this
Channel
Open WAN Interface for
this Channel
WAN Connection
Detection
92
available. The user will be able to select the physical WAN
interface the channel shall use here.
VPI - Type in the value provided by your ISP.
VCI - Type in the value provided by your ISP.
Protocol - Select a proper protocol for this channel.
Encapsulation - Choose a proper type for this channel. The
types will be different according to the protocol setting
that you choose.
Add VLAN Header – Check the box to enable the following
two options.
VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network
traffic flowing on each channel will be identified by the
system via their VLAN Tags. Channels using the same WAN
type may not configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Such function is available only when ADSL is selected as
WAN Type.
QoS Type - Select a proper QoS type for the channel.
Type the values for PCR, SCR and MBS respectively.
The settings here will create a bridge between the LAN
ports selected and the WAN. The WAN interface of the
bridge connection will be built upon the WAN type selected
using the VLAN tag configured.
Physical Members – Group the physical ports by checking
the corresponding check box(es) for applying the port-based
bridge connection.
Check the box to enable relating function.
WAN Application –
Management – It can be specified for general

management (Web configuration/telnet/TR069). If you
choose Management, the configuration for this VLAN
will be effective for Web configuration/telnet/TR069.
 IPTV - The IPTV configuration will allow the WAN
interface to send IGMP packets to IPTV servers.
VoIP- The VoIP configuration will allow the WAN

interface created here to send SIP registration packets
and other VoIP management packets.
Such function is available only when ADSL is selected as
WAN Type.
It allows you to verify whether network connection is alive
or not through ARP Detect or Ping Detect.
Mode – Choose ARP Detect or Ping Detect for the system to
execute for WAN detection. If you choose Ping Detect as the
detection mode, you have to type required settings for the
following items.

Primary/Secondary Ping IP – If you choose Ping Detect
as detection mode, you have to type Primary or
Secondary IP address in this field for pinging.

Ping Gateway IP – If you choose Ping Detect as
detection mode, you also can enable this setting to use
current WAN gateway IP address for pinging.
Vigor2762 Series User's Guide