Draytek Vigor2762 series User Manual page 100

Click any index (7~10) to get the following web page:
Available settings are explained as follows:
Item
Multi-VLAN Channel 7~10
WAN Type
General Settings
Bridge mode
90
Description
Enable – Click it to enable the configuration of this channel.
Disable –Click it to disable the configuration of this channel.
The connections and interfaces created in every channel
may select a specific WAN type to be built upon. In the
Multi-VLAN application, only the Ethernet WAN type is
available. The user will be able to select the physical WAN
interface the channel shall use here.
VPI - Type in the value provided by your ISP.
VCI - Type in the value provided by your ISP.
Protocol - Select a proper protocol for this channel.
Encapsulation - Choose a proper type for this channel. The
types will be different according to the protocol setting
that you choose.
Add VLAN Header – Check the box to enable the following
two options.
VLAN Tag – Type the value as the VLAN ID number. Valid
settings are in the range from 1 to 4095. The network
traffic flowing on each channel will be identified by the
system via their VLAN Tags. Channels using the same WAN
type may not configure the same VLAN tag value.
Priority – Choose the number to determine the packet
priority for such VLAN. The range is from 0 to 7.
Enable – Click it to enable Bridge mode for such channel.
Physical Members – Group the physical ports by checking
the corresponding check box(es) for applying the bridge
Vigor2762 Series User's Guide