Draytek Vigor2762 series User Manual page 481

-e
ATTACK_0
-d
Example
Example
>dos –A
The Dos Defense system is Activated
>dos –s synflood 50 10
Synflood is enabled! Threshold=50 <pke/sec> timeout=10 <pke/sec>
Telnet Command:
Telnet Command:
Type this command will leave telnet window.
Telnet Command:
Telnet Command:
This command allows you to configure detailed settings for WAN connection.
Syntax
Syntax
internet -W n -M n [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
-W n
-M n
<command><parameter>|...]
-S <isp name>
-P <on/off>
-u <username>
-p <password>
-a n
-t n
Vigor2762 Series User's Guide
Enable defense function for a specific attack(s).
Specify a name of the following attacks: ip_option, tcp_flag, land,
teardrop, smurf, pingofdeath, traceroute, icmp_frag, syn_frag,
unknow_proto, fraggle.
Disable the defense function for a specific attack(s).
exit
exit
Internet
Internet
Description
W means to set WAN interface.
1=WAN1, 2=WAN2,.... Default is WAN1.
M means to set Internet Access Mode (Mandatory) and n means
different modes (represented by 0 – 3)
n=0: Offline
n=1: PPPoE
n=2: Dynamic IP
n=3: Static IP
n=4: PPTP with Dynamic IP,
n=5: PPTP with Static IP,
n=6: L2TP with Dynamic IP
n=7: L2TP with Static IP
n=A: 3G/4G USB Modem(PPP mode),
n=B: 3G/4G USB Modem(DHCP mode)
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Set ISP Name (max. 23 characters).
Enable PPPoE Service.
Set username (max. 49 characters) for Internet accessing.
Set password (max. 49 characters) for Internet accessing.
It means to set PPP Authentication Type and n means different
types (represented by 0-1).
n=0: PAP/CHAP (this is default setting)
n=1: PAP Only
Set connection duration and n means different conditions.
n=-1: Always-on
471