Draytek Vigor2762 series User Manual page 461

Example Example
> adsl ppp o 35 8 1 1 4 1 -1 draytek draytek
pvc no.=0
vci=35
vpi=8
encap=LLC(1)
proto=PPPoE(1)
modu=MULTI(4)
AcquireIP: Dhcp_client(1)
Idle timeout:-1
Username=draytek
Password=draytek
Telnet Command:
Telnet Command:
This command can specify a LAN port (LAN1 to LAN4) for mapping to certain PVC, and the
mapping port/PVC will be operated in bridge mode.
adsl bridge [pvc_no/status/save/enable/disable] [on/off/clear/tag tag_no] [service type]
[px ... ]
Syntax Description
Syntax Description
Parameter
Parameter
pvc_no
status
save
enable
disable
on/off
clear
tag tag_no
pri pri_no
service type
px...
Example
Example
> adsl bridge 4 on p2 p3
Vigor2762 Series User's Guide
adsl bridge
adsl bridge
Description
Description
It means pvc number and must be between 0(Channel 1)
to 7(Channel 8).
It means to shown the whole bridge status.
It means to save the configuration to flash.
It means to enable the Multi-VLAN function.
It means to disable the Multi-VLAN function.
It means to turn on/off bridge mode for the specific
channel.
It means to turn off and clear all the PVC settings.
No tag: -1
Available number for tag: 0-4095
The number 0 to 7 can be set to indicate the priority. "7"
is the highest.
Two number can be set:
0: for Normal (all the applications will be processed with
the same PVC).
1: for the IGMP with different PVC which is used for
special ISP.
It means the number of LAN port (x=2~4). Port 1 is locked for
NAT.
451