Draytek Vigor2762 series User Manual page 506

Telnet Command:
Telnet Command:
This command allows you to configure settings for accessing Internet.
Syntax Syntax
ip6 internet -W n -M n [-<command> <parameter> | ... ]
Syntax Description
Syntax Description
Parameter
-W n
-M n
[<command>
<parameter>|...]
For 6rd
-C n
-s [server]
-m n
-p [prefix]
-l n
For 6in4
-s [server]
-I [IPv6 Addr]
-P n
-p [prefix]
-l n
496
ip6 internet
ip6 internet
Description
W means to set WAN interface and n means different selections.
Default is WAN1.
n=1: WAN1
n=2: WAN2
n=3: WAN3
.
.
n=X: WANx
M means to set Internet Access Mode (Mandatory) and n means
different modes (represented by 0 – 5)
n= 0: Offline,
n=1: PPP,
n=2: TSPC,
n=3: AICCU,
n=4: DHCPv6,
n=5: Static
n=6: 6in4-Static
n=7: 6rd
The available commands with parameters are listed below.
[...] means that you can type in several commands in one line.
Set 6rd Connection Mode.
n = 0: Auto
n = 1: Static.
Set 6rd IPv4 Border Relay.
server= IPv4 address
Set 6rd IPv4 address mask length.
n=1 to 32.
Set 6rd IPv6 prefix.
prefix= IPv6 address
Set 6rd IPv6 prefix length.
n=1 to 64.
Set 6in4 Remote Endpoint IPv4 Address.
server= IPv4 address
Set 6in4 IPv6 Address.
IPv6 Addr= IPv6 address.
Set 6in4 IPv6 WAN prefix length.
n=1 to 64. (Default number is 64)
Set 6in4 LAN Routed Prefix.
prefix= IPv6 address
Set 6in4 LAN Routed Prefix length.
n=1 to 64. (Default number is 64)
Vigor2762 Series User's Guide