Enabling And Configuring Thresholds On The Optical Inline Amplifier Performance; Monitors - Juniper PTX3000 IPLC Features Manual

Related
Documentation

Enabling and Configuring Thresholds on the Optical Inline Amplifier Performance

Monitors

Copyright © 2018, Juniper Networks, Inc.
To view the status of the IPLC module, use the
status command.
To view the current alerts, use the
command.
To display alerts in 15-minute intervals, use the
pm-interval command.
To view the 24-hour alerts, use the
pm-currentday command.
To view the alerts from the previous day, use the
optical-properties pm-previousday
Integrated Photonic Line Card Base and Expansion Module Overview on page 3
Understanding the Integrated Photonic Line Card Architecture on page 6
Understanding Optical Supervisory Channel Communication in the Amplifier Chain on
page 11
Configuring the Optical Supervisory Channel Across the Amplifier Chain of the PTX3000
Integrated Photonic Line System on page 33
Enabling and Configuring Thresholds on the Optical Inline Amplifier Performance
Monitors on page 51
Performance monitors monitor the health of the optical inline amplifier (ILA) at various
points on the optical ILA hardware based on threshold crossing alerts (TCA)s. TCAs can
give the management system an early indication as to the state of the associated entity
when it crosses a certain threshold. TCAs are alerts that are activated when a certain
configurable threshold—near-end measurement threshold or far-end measurement
threshold—is crossed and remains so until the end of the 15-minute interval and the
24-hour interval. The timely detection of TCAs is essential to proactively manage the
optical ILA. TCAs are not an indication of a fault, but rather an indication that the entity
may be close to a fault. You can enable the TCA that you want monitor. You can keep
the default threshold settings or change the settings.This topic describes how to configure
TCAs for the optical ILA performance monitors.
NOTE: By default, TCAs are disabled.
Chapter 7: Configuring Performance Monitor Thresholds
show chassis fpc optical-properties
show chassis fpc optical-properties pm-current
show chassis fpc optical-properties
show chassis fpc optical-properties
show chassis fpc
command.
51