Ford Transit 2002 Owner's Manual page 1289

electrical connector.
CAUTIONS:
19.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft oil seal.
NOTE: Install a new halfshaft center bearing
cap and new locknuts.
Attach the right-hand halfshaft and the
intermediate shaft to the transaxle.
Install the halfshaft center bearing cap.
CAUTIONS:
20.
Support the halfshaft. The inner joint
must not be bent more than 18 degrees. The
outer joint must not be bent more than 45
degrees.
Do not damage the halfshaft oil seal.
Make sure the snap ring is correctly
seated.
NOTE: Install a new snap ring.
Attach the left-hand halfshaft to the transaxle.
21. Attach the gearshift cables to the transaxle.
1. Attach the gearshift cable to the bracket
and turn the abutment sleeve
counterclockwise.
2. Attach the selector cable to the bracket
and turn the abutment sleeve
counterclockwise.
22. Adjust the gearshift cables.
For additional information, refer to:
Cable Adjustment
Transmission/Transaxle and Clutch - General
Information, General Procedures).
23. Install the crossmember.
For additional information, refer to:
Crossmember (502-00 Uni-Body, Subframe and
Mounting System, Removal and Installation).
24. Lower the vehicle.
http://vnx.su
Gearshift
(308-00 Manual