Enabling Tperf Test Mode; Configuring Qos Percentages; Configuring Ipsec And Ike Policies - Brocade Communications Systems Brocade 8/12c User Manual

20
Configuring FCIP tunnel advanced settings
4. Click OK.

Enabling Tperf test mode

To enable Tperf test mode, do the following:
1. Select Advanced Settings on the Add FCIP Tunnel dialog box to display the Advanced Settings
2. From the Transmission tab, select the TPerf Test Mode check box.
3. Select the Tape Acceleration check box.
4. Click OK.
Tperf test mode should not be enabled during normal operations. It is only used for testing and
troubleshooting tunnels. Refer to the Fabric OS FCIP Administrator's Guide for information about
Tperf.

Configuring QoS percentages

For 8 Gbps platforms, you can adjust QoS (Quality of Service) priority percentages from the preset
default values of 50% (High), 30% (Medium), and 20% (low). Values for the three priority levels
must equal 100%. A minimum of 10% is required for each level. You can adjust percentages in
increments of 1%. To configure QoS percentages, do the following:
1. Select Advanced Settings on the Add FCIP Tunnel dialog box to display the Advanced Settings
2. From the Transmission tab, click the up and down arrows by the QoS (High), QoS (Medium),

Configuring IPSec and IKE policies

IPSec and IKE policies are configured from the Security tab. The screens and procedures are
platform-dependent.
and 8 Gbps Extension Blade.
1. Select Advanced Settings on the Add FCIP Tunnel dialog box to display the Advanced Settings
2. Select the Security tab.
654
dialog box.
dialog box.
and QoS (Low) percentage values to increase and decrease values.
Figure 292
dialog box.
on page 655 shows the screen for the 8 Gbps Extension Switch
Document Title
xx-xxxxxxx-01