Enabling Access Gateway Mode; Figure 51 Port Group Configuration-View Only - Brocade Communications Systems 8 Administrator's Manual

12

Enabling Access Gateway mode

•
•
•

Enabling Access Gateway mode

When you enable Access Gateway mode some fabric information, such as the zone and security
databases, is erased. To recover this information, save the switch configuration before enabling
Access Gateway mode.
To save the switch configuration using Web Tools, click Switch Admin in the Manage section under
Tasks, and then select the Configure > Upload/Download subtab and upload the configuration file.
NOTE
You cannot enable Access Gateway mode if Management Server is enabled. To disable Management
Server, enter the MsplmgmtDeactivate command.
162
DRAFT: BROCADE CONFIDENTIAL
Configure N-Port Groups — You can only view the port group details from the Port Group
Configuration window. The following options are disabled as shown in
-
Disable N-port Grouping
-
Add
-
Edit/View
-
Delete
FIGURE 51
Port Group Configuration—view only
Configure F-N Port Mappings — Add and Remove buttons are disabled for primary mappings
and secondary failover mapping.
N Port Configuration — By default all the ports are set to N_Ports and failover and fallback are
disabled. You can edit the speed. The following options are disabled in the N Port Configuration
window:
-
Lock as N Port
-
Allow as F, U Port
-
Enable N Port Failover Policy
-
Enable N Port Fallback Policy
Figure 51:
Web Tools Administrator's Guide
53-1001772-01