Cable The Three-Or-More Cabinet Avaya Ip600 System; Install Rmc Patch Panels And External Modem; Install Patch Panels And Shelf - Avaya DEFINITY ONE Installation And Upgrades

Installation and Upgrades for DEFINITY ONE and
IP600 Internet Protocol Release 10 555-233-109
1 Install and Cable the Cabinet

Install RMC patch panels and external modem

Cable the three-or-more cabinet Avaya IP600 system

Since connecting multiple cabinets involves the same basic procedures, follow the
instructions in
Install RMC patch panels and external
modem
NOTE:
The optional patch panel kit replaces standard 110A cross-connect hardware. If
standard 110A cross-connect equipment is used, consult DEFINITY Communications
System Generic 1 and Generic 3 Main Distribution Field Design (555-230-630).
Patch panels are arrays of RJ45 jacks and associated B25A cabling to
accommodate 2-wire, 24-port DCP/analog port boards and 8-port analog trunk
boards.
A shelf is provided to serve as a mounting surface for the external modem and
other optional equipment. The shelf can also be used to secure the B25A cables.

Install patch panels and shelf

Refer to Figure 1-17 on page 1-35
1. Using the supplied mounting screws, mount the patch panels on the rack
below processor cabinet.
2. Using the supplied mounting screws, mount the shelf on the rack below the
patch panels.
3. Attach B25A cables to the patch panels and the circuit pack amphenol
connectors.
''Cable the two-cabinet Avaya IP600 system'' on page
NOTE:
Connect 24 port DCP/analog circuit packs to the 24 port patch
panels.
NOTE:
Connect 8 port analog trunk, "combo," or DID trunk circuit packs to
either of the first two banks on the 8 port patch panel. If an 8 port BRI
trunk circuit pack (TN2185B) is present, connect it to the third bank
on the 8 port patch panel.
NOTE:
The patch panels do not have to be mounted in the same rack as the
cabinet. They can be mounted in phone closets as appropriate.
while performing this procedure.
Issue 6
December 2001
1-34
1-29.