Management Interface; Console Port - Supermicro SSE-F3548S User Manual

1.3 Management Interface

The Supermicro switch command line interface (CLI) is accessible through an RS232 console port, or
viaTelnet and SSH connections. The CLI is designed to follow industry standard CLI commands.
Standard features including context sensitive "help" and auto-completion-on-tab-key are supported.
Log into the switch with the following default ID and Password:
ID: ADMIN
PW: ADMIN
[Note: ADMIN/ADMIN are default login ID and password for all Supermicro switches.]
After you log into the switch CLI, you are automatically placed in the user EXEC mode. This mode
supports "show" commands and minimal configuration commands.
To enter the configuration mode, use the command "configure terminal". For example:
SMIS# configure terminal
SMIS(config)#
To exit to EXEC mode, use the command exit or end.

1.3.1 Console Port

The SSE-G3548S/R has an RJ45 connector for the RS232 console port.
Use the serial cable provided with the switch to connect the RS232 port to any computer.
The computer COM port settings should be as follows:
Baudrate: 115200
Data: 8 bit
Parity: none
Stop: 1 bit
Flow Control: none
Further information on Management Access can be found in Section 2.2 of this manual.
Supermicro SSE-F3548S/SSE-F3548SR Configuration User's Guide 15