Statistics Refresh Timer; Interface Properties - Supermicro SSE-G48-TG4 Configuration Manual

SMIS(config)# web session-timeout 500
SMIS(config)# end

1.3.4 Statistics Refresh Timer

The statistics pages can be configured to automatically refresh periodically. The web statistics refresh
timer is configurable through a CLI command.
Follow the steps below to configure the Statistics Refresh Timer.
Step Command
Step 1 configure terminal
Step 2 statistics refresh-timer <integer(0-9999)>
Step 3 end
Step 4 write startup-config
The example below shows the commands used to configure the Statistics Refresh Timer.
SMIS# configure terminal
SMIS(config)# statistics refresh-timer 5000
SMIS(config)# end

1.4 Interface Properties

Supermicro switches support various types of interfaces: physical interfaces, port channel interfaces and
VLAN interfaces. Each interface has different characteristics, some of which are configurable.
Defaults – Interface Properties
Parameter
MTU
Speed
Negotiation
Storm-control
Description
Duplex Operation
Flow Control
Default Value
1500 bytes
For 1 – 1Gbps
For 10 – 10Gbps
For 40 – 40Gbps
For 1G interfaces – Auto
For 10GBaseT interfaces – Auto
For all other types of 10G interfaces – No negotiation
For 40G interfaces - No negotiation
Disabled
None
Full
Off
Supermicro L2/L3 Switches Configuration Guide
Description
Enters the configuration mode.
Configures the Statistics Refresh Timer
to between 1-9999 seconds.
Exits the configuration mode.
Optional step – saves this configuration
to be part of the startup configuration.
17