Configure Mpls Vpls Add - Extreme Networks ExtremeWare Command Reference Manual

configure mpls vpls add

config mpls vpls <vpls_name> add [vlan <vlan_name> |
Description
Configures service for VPLS.
Syntax Description
vpls_name
vlan_name
port-list
Default
N/A
Usage Guidelines
This command configures a local Ethernet VPLS interface for the specified
interface may be a VLAN or a physical port. Specifying the
specified vpls. Only one VLAN may be configured per VPLS. Specifying a port-list logically binds one
or more physical ports to the specified vpls. Only ports configured for
directly added to a vpls (see Configure MPLS Edge Service Mode on page 3 for additional information).
Edge-service-mode
VLAN ID (and not the port) is the service identifier. If multiple ports are added or there are multiple
ports configured for vlan_name, VPLS traffic local to the switch is forwarded within the switch.
Simultaneous support for both vlan and ports for a single vpls is not supported.
When a vlan interface has been configured for a VPLS, the VLAN is added to the VPLS as specified by
the v
pls_name
within the H-VPLS network, may have a different VLAN ID. This greatly simplifies VLAN ID
coordination between metro network access points. Traffic may be switched locally between VLAN
ports if more than one port is configured for the VLAN.
When a port interface has been configured for a VPLS, the port-list is automatically added to a unique
VMAN ID. The VMAN ID assigned, is the highest unallocated VLAN ID. The VMAN allocated for the
VLAN ID has the same name as the configured VPLS instance (i.e.,
switch ports added to the VPLS are implicitly added to the VMAN. The VMAN ID uniquely maps to a
and thus identifies the ports that have been added to the Port VPLS interface. Because the
vpls_name
VMAN ID must uniquely identify the port, the port cannot be added to any other local VLAN.
Example
config mpls vpls myvpls add [vlan <vlan_name> |
config mpls vpls myvpls add myvlan
config mpls vpls myvpls add ports 1:5
History
This command was first available in an ExtremeWare 7.3.0.
ExtremeWare 7.5 Command Reference Guide
Identifies the VPLS interface within the switch (character string)
Logically binds the VLAN to the specified vpls.
Specifies a list of ports.
vlan ports must be added to a VLAN and the VLAN assigned to a vpls, since the
. The VLAN ID is locally significant to each VPLS. Thus, each VLAN VPLS interface
ports <port-list>]
vpls_name
logically binds the VLAN to the
vlan_name
edge-service-mode
). Any additional local
vpls_name
ports <port-list>]
configure mpls vpls add
. The VPLS
port can be
2487