Configure Mpls Vpls Peer - Extreme Networks ExtremeWare Command Reference Manual

MPLS Commands—BlackDiamond Switch Only

configure mpls vpls peer

config mpls vpls <vpls_name> peer [<ipaddress> | <host_name>] [add |
delete] [lsp <lsp_name>]
Description
Configures additional LSPs to a VPLS peer.
Syntax Description
vpls_name
ipaddress
host_name
add
delete
lsp_name
Default
N/A.
Usage Guidelines
This command configures additional LSPs to a VPLS peer. The
four RSVP-TE LSPs to the VPLS peer. Traffic to the VPLS peer is aggregated across all configured LSPs.
LSP traffic aggregation is described in Equal-cost Multipath LSP Support on page 3. The
keyword will remove the LSP specified by the
all the LSPs are deleted, the VC-LSP will attempt to use the best-routed path LSP, if one exists. If no
LSPs exist to the VPLS peer, VPN connectivity to the VPLS peer is lost.
Example
None
History
This command was first available in an ExtremeWare 7.3.0.
Platform Availability
This command is available on the BlackDiamond switch only.
2494
Identifies the VPLS within the switch (character string)
Specifies the IP address for the peer node that is the endpoint of the VC-LSP
Specifies the peer host name.
Permits addition of up to four RSVP-TE LSPs to the VPLS peer.
Removes the LSP specified by the lsp_name parameter from the VC-LSP
aggregation list.
Removes the specified lsp.
lsp_name
keyword may be used to add up to
add
parameter from the VC-LSP aggregation list. If
delete
ExtremeWare 7.5 Command Reference Guide