Configure Mpls Rsvp-Te Vlan - Extreme Networks ExtremeWare Command Reference Manual

MPLS Commands—BlackDiamond Switch Only

configure mpls rsvp-te vlan

configure mpls rsvp-te vlan [<vlan name> | all] {hello-interval <seconds>}
{refresh-time <seconds>} {summary-refresh-time <tenth-seconds>}
{bundle-time <tenth-seconds>} {keep-multiplier <number>}
Description
Configures RSVP-TE protocol parameters
Syntax Description
vlan name Specifies the VLAN name.
hello-interval Specifies the RSVP hello packet transmission interval.
refresh-time Specifies the interval for sending refresh path messages.
bundle-time Specified the maximum amount of time a transmit buffer is held so that multiple RSVP
messages can be bundled into a single PDU.
summary-refresh-time Specifies the time interval for sending summary refresh RSVP messages.
Default
N/A
Usage Guidelines
This command configures the RSVP-TE protocol parameters for the specified VLAN. The RSVP-TE
keyword indicates that the configuration changes apply to all RSVP-TE enabled VLANs.
all
The time specifies the RSVP hello packet transmission interval. The RSVP hello packet
hello-interval
is used by the switch to detect when a RSVP-TE peer is no longer reachable. If an RSVP hello packet is
not received from a peer with [hello-interval *
and all RSVP sessions to and from that peer are torn down. The default
seconds with a valid range from one to 60 seconds.
The specifies the interval for sending refresh path messages. RSVP refresh messages
refresh-time
provide "soft state" link-level keep-alive information for previously established paths and enables the
switch to detect when an LSP is no longer active. RSVP sessions are torn down if an RSVP refresh
message is not received from a neighbor within [(
seconds. The default
refresh-time
minimum and maximum
The minimum and maximum
The , specified in tenths of a second, indicates the maximum amount of time a transmit
bundle-time
buffer is held so that multiple RSVP messages can be bundled into a single PDU. The default
is zero, indicating that RSVP message bundling is not enabled. The
bundle-time
may be set to any value between zero and 30 (or 3 seconds).
The
summary-refresh-time
summary refresh RSVP messages. The
. The default
refresh-time
2476
keep-multiplier
keep-multiplier
is 30 seconds and the default
values are one and 36,000 seconds (or one hour) respectively.
refresh-time
values are one and 255 respectively.
keep-multiplier
, specified in tenths of a second, indicates the time interval for sending
summary-refresh-time
summary-refresh-time
] seconds, the peer is declared down
hello-interval
+ 0.5) * 1.5 *
keep-multiplier
must be less than the configured
is zero, indicating that no summary refresh RSVP
time is three
]
refresh-time
value is three. The
value
bundle-time
ExtremeWare 7.5 Command Reference Guide