Protocol; Redirect - Dell PowerConnect 6224 Command Line Interface Manual

protocol

Use the protocol command to configure the protocol mode for a captive
portal configuration.
Syntax
protocol { http | https }
Default Configuration
The default protocols mode is https.
Command Mode
Captive Portal Instance mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-CP 2)#protocol http

redirect

Use the redirect command to enable the redirect mode for a captive portal
configuration. Use the "no" form of this command to disable redirect mode.
Syntax
redirect
no redirect
Default Configuration
Redirect mode is disabled by default.
Command Mode
Captive Portal Instance mode.
1071
Captive Portal Commands