Snmp-Server Engineid Local - Dell PowerConnect 6224 Command Line Interface Manual

Default Configuration
Traps are enabled by default.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the command to enable authentication failed
SNMP traps.
console(config)# snmp-server enable traps
authentication

snmp-server engineID local

Use the snmpserver engineID local command in Global Configuration mode
to specify the Simple Network Management Protocol (SNMP) engine ID on
the local device.
To remove the configured engine ID, use the no form of this command.
Syntax
snmp-server engineID local {
no snmp-server engineID local
• engineid-string — The character string that identifies the engine ID. The
engine ID is a concatenated hexadecimal string. Each byte in hexadecimal
character strings is two hexadecimal digits. Each byte can be separated by
a period or colon. (Range: 6-32 characters)
• default — The engineID is created automatically, based on the device
MAC address.
Default Configuration
engineID
The
1250
SNMP Commands
engineid-string
is not configured.
| default }