Dot1X Timeout Supp-Timeout - Dell PowerConnect 6224 Command Line Interface Manual

User Guidelines
The actual timeout is this parameter or the product of the Radius
transmission times the Radius timeout, whichever is smaller
Example
The following example sets the time for the retransmission to the
authentication server to 3600 seconds.
console(config-if-1/g1)# dot1x timeout server-timeout
3600

dot1x timeout supp-timeout

Use the dot1x timeout supp-timeout command in Interface Configuration
mode to set the time that the switch waits for a response before
retransmitting an Extensible Authentication Protocol (EAP)-request frame to
the client. To return to the default setting, use the no form of this command.
Syntax
dot1x timeout supp-timeout
no dot1x timeout supp-timeout
seconds — Time in seconds that the switch should wait for a response to
•
an EAP-request frame from the client before resending the request.
(Range: 1–65535)
Default Configuration
The period of time is set to 30 seconds.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
Change the default value of this command only to adjust for unusual
circumstances, such as unreliable links or specific behavioral problems with
certain clients and authentication servers.
628
802.1x Commands
seconds