Show Ipv6 Ospf - Dell PowerConnect 6224 Command Line Interface Manual

Example
The following example sets a 4-digit dotted-decimal number identifying the
Router OSPF ID as 2.3.4.5.
console(config)#ipv6 router ospf
console(config-rtr)#router-id 2.3.4.5

show ipv6 ospf

Use the show ipv6 ospf command in Privileged EXEC mode to display
information relevant to the OSPF router.
Syntax
show ipv6 ospf
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode.
User Guidelines
Some of the information below displays only if you enable OSPF and
configure certain features. The following fields may be displayed:
Router ID
OSPF Admin
Mode
External LSDB
Limit
Exit Overflow
Interval
968
OSPFv3 Commands
A 32-bit integer in dotted decimal format identifying the router
about which information is displayed. This is a configured value.
Shows whether OSPF is administratively enabled or disabled.
Shows the maximum number of non-default external LSAs
entries that can be stored in the link-state database.
Shows the number of seconds that, after entering
OverflowState, as defined by RFC 1765, a router will attempt to
leave OverflowState.