Ip Route Distance - Dell PowerConnect 6224 Command Line Interface Manual

preference — Specifies the preference value, a.k.a administrative distance,
•
of an individual static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For routed management traffic:
1 Router entries are checked for applicable destinations.
2 The globally assigned default-gateway is consulted.
Router entries take precedence over an assigned default-gateway.
Example
The following example identifies the
200.
console(config)#ip route 192.168.10.10 255.255.255.0
192.168.20.1 200

ip route distance

Use the ip route distance command in Global Configuration mode to set the
default distance (preference) for static routes. Lower route preference values
are preferred when determining the best route. The ip route and ip route
default commands allow optional setting of the distance of an individual
static route. The default distance is used when no distance is specified in
these commands. Changing the default distance does not update the
distance of existing static routes, even if they were assigned the original
default distance. The new default distance are applied to static routes created
after invoking the ip route distance command.
Syntax
ip route distance
integer
next-hop-ip
and a preference value of
IP Routing Commands
725