Dell PowerConnect 6224 Command Line Interface Manual page 465

match dstip6
The match dstip6 command adds to the specified class definition a match
condition based on the destination IPv6 address of a packet.
Syntax
destination-ipv6-prefix/prefix-length
match dstip6
destination-ipv6-prefix — IPv6 prefix in IPv6 global address format.
•
prefix-length —IPv6 prefix length value.
•
Default Configuration
There is no default configuration for this command.
Command Mode
Ipv6-Class-Map Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(config-classmap)#match dstip6 2001:DB8::/32
match dstl4port
Use the match dstl4port command in Class-Map Configuration mode to add
to the specified class definition a match condition based on the destination
layer 4 port of a packet using a single keyword or a numeric notation.
Syntax
match dstl4port {
portkey — Specifies one of the supported port name keywords. A match
•
condition is specified by one layer 4 port number. The currently supported
values are: domain, echo, ftp, ftpdata, http, smtp,snmp, telnet, tftp, and
www.
port-number — Specifies a layer 4 port number (Range: 0–65535).
•
portkey port-number
| }
QoS Commands
465