spanning-tree disable
Use the spanning-tree disable command in Interface Configuration mode to
disable spanning-tree on a specific port. To enable spanning-tree on a port,
use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
This command has no user guidelines.
Example
The following example disables spanning-tree on 1/g5.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree disable
spanning-tree forward-time
Use the spanning-tree forward-time command in Global Configuration
mode to configure the spanning-tree bridge forward time, which is the
amount of time a port remains in the listening and learning states before
entering the forwarding state.
To reset the default forward time, use the no form of this command.
Syntax
seconds
spanning-tree forward-time
545
Spanning Tree Commands