Dell PowerConnect 6224 Command Line Interface Manual page 787

Syntax
ipv6 pimdm hello-interval
no ipv6 pimdm hello-interval
• interval - The hello interval time in seconds (Range: 0–65535).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan5)#ipv6 pimdm hello-interval
500
ipv6 route
Use the ipv6 route command in Global Configuration mode to configure an
IPv6 static route.
Syntax
ipv6-prefix
ipv6 route
vlan-id next-hop-address
vlan }]
ipv6-prefix
no ipv6 route
vlan-id next-hop-address
vlan }]
ipv6-prefix — Is the IPv6 network that is the destination of the static
•
route.
prefix-length — Is the length of the IPv6 prefix — a decimal value (usually
•
0-64) that shows how many of the high-order contiguous bits of the
address comprise the prefix (the network portion of the address). A slash
mark must precede it.
interval
prefix-length
/ [Null | interface {tunnel
preference
[
prefix-length
/
]
[Null | interface {tunnel
IPv6 Routing Commands
tunnel-id
|
tunnel-id
|
787