Ip Ospf Transmit-Delay; Maximum-Paths - Dell PowerConnect 6224 Command Line Interface Manual

console(config-if-vlan15)#ip ospf retransmit-interval
50

ip ospf transmit-delay

Use the ip ospf transmit-delay command in Interface Configuration mode to
set the OSPF Transit Delay for the specified interface. Use the no form of the
command to return the delay to the default value.
Syntax
ip ospf transmit-delay
no ip ospf transmit-delay
seconds — Sets the estimated number of seconds it takes to transmit a link
•
state update packet over this interface. (Range: 1–3600 seconds)
Default Configuration
1 is the default number of seconds.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF Transit Delay for VLAN 15 at 20
seconds.
console(config-if-vlan15)#ip ospf transmit-delay 20

maximum-paths

Use the maximum-paths command in Router OSPF Configuration mode to
set the number of paths that OSPF can report for a given destination. Use the
no form of the command to reset the number to the default value.
seconds
OSPF Commands
889